All values measured to ground unless otherwise noted | |||
A37/4, A37/5 |
|||
A.2 | SN2 processed unlocking signal output, to CF system |
Initialize and hold locking command measure to circuit 30 pin 2 12 VDC |
activation with key or IR transmitter Note 1 |
A.3 | SN1 processed locking signal output, to CF system |
Initialize and hold unlocking command measure to circuit 30 pin 2 12 VDC |
activation with key or IR transmitter Note 1 |
B.1 | Circuit 15 main power input | Ignition on 12 VDC | Feed from F1f24 |
B.2 | REST function recognition signal input | Ignition off, engine coolant temp > 50 ° C, disconnect transparent line at PSE module, press REST on N22 12 VDC, PSE will turn on |
|
C.1 | Unlock command driver/passenger side / trunk signal input | Disconnect A37 plugs, in rest position > 20 kOhms in unlock mode <40 Ohms |
Initialized from S86/1, S87/1 and S88/2 |
C.2 | Main ground to W7 | Approx. 0 Ohms to ground | |
C.3 | Lock command driver/passenger side / trunk signal input | Disconnect A37 plugs, in rest position > 20 kOhms in unlock mode <60 Ohms |
Initialized from S86/1, S87/1 and S88/2 |
C.4 | Interior dome lamp activation signal output | Lock vehicle < 1 VDC, E15 will not be lit Unlock vehicle > 12 VDC, E15 will be lit |
|
C.5 | Rear door contact switch signal input | All rear doors closed 12 VDC any rear door open < 1 VDC |
|
C.6 | Interior CL signal input from S85/1 | "unlock" position 12 VDC "lock" position < 1VDC |
|
C.7 | Immobilization signal output, prevents start lock-out if a legal unlock procedure is not recognized |
Vehicle unlocked 12 VDC open left front window and lock vehicle ignition on < 1 VDC |
valid as of 12/93 |
C.8 | Circuit 30 main power input, supplies PSE pump |
12 VDC at all times | Feed from F1f27 via Z7/1 |
Note | For further tests, especially pneumatic system, refer to DM Body and Accessories Vol 1 sect. 3 | ||
Note 1 | SN1 lock signal will cause to close windows and/or sliding/pop-up roof if open | SN2 unlock signal will cause to open windows and/or sliding/pop-up roof with delay of approx. 2-4 sec. (immediately if not have been closed completely before, but only within 15 sec. of a closing operation) |