All values measured to ground unless otherwise noted
Conn./Plug/Pin Pin Information Test Value Comments
N7      
 
1.4
1.5		 Circuit 56b voltage supply output,
Right front low beam lamp
Left front low beam lamp		 Lights on, S1 in pos. II,
S4 in low beam pos. 12 VDC
 Note
 
2.7
2.8		 Circuit 58, left taillamp voltage supply
auxiliary taillamp
tail/parking lamp		 Engine running 12 VDC or
Lights on, S1 in pos. I or II, 12 VDC
 Feed from S1 pin10 via F1f16 to pin 3.7
Note
 
2.15
2.16		 Circuit 58, right taillamp voltage supply
auxiliary taillamp
tail/parking lamp		 Lights on, S1 in pos. I or II, 12 VDC Feed from S1 pin 3 via F1f15
to pin 3.16
 
3.1
3.2		 Circuit 56b, fused voltage input,
left low beam
right low beam		 Engine running 12 VDC or
Lights on, S1 in pos. II,
S4 in low beam pos. 12 VDC 		Feed from either S1 pin1 via S4s3
or N35 pin7 Note
3.7 Circuit 58, left tail/parking lamp fused voltage input Engine running 12 VDC or
Lights on, S1 in pos. I or II, 12 VDC		 Note
3.13 Main ground to W1 Approx. 0 Ohms to ground  
3.16 Circuit 58, right tail/parking lamp fused voltage input Engine running 12 VDC or
Lights on, S1 in pos. I or II, 12 VDC		 Note
N35     Note
 
1
2		 Circuit Ke, license plate lamp voltage
output
lights on feedback input from F1/1f9		 Engine running, S1 in pos. 0 12 VDC  
3 Circuit 61 signal input, activates "lights on" relays in N35 Engine running, S1 in pos. 0 12 VDC
Daytime running lamps on		 see pin5
4 Circuit 30 main power input 12 VDC all times  
5 Circuit 15 relay voltage supply high side,
enables "lights on" relays in N35		 Ignition o n 12 VDC relays are activated by circ. 61 (see pin3)
6 Circuit 50 starter lockout voltage,
lights on inhibit signal input		 Start engine 12 VDC while starter cranks
Engine running <2 VDC		 Lights not on
Lights on
7 Circuit 56b low beam voltage supply output, Engine running, S1 in pos. 0 12 VDC low beam lights on
8 Pin not used    
9 Main ground to W1 Approx. 0 Ohms to ground  
10 High beam lights on signal input
deactivates low beam relay in N35		 Engine running low beam mode < 2VDC
switch S4 to high beam pos. 12 VDC 		 
 
11
12		 Circuit 58 taillamp voltage supply output
left taillamp
right taillamp 		Engine running, S1 in pos. 0 12 VDC  
Feed to F1f16
Feed to F1f15
Note daytime running light feature switches on
Marker lamps
Low beam headlamps
Taillamps
License plate lamps
as soon as engine is running		 The daytime running light function is canceled by switching on the parking lights or low beam headlamps with exterior light switch S1.