MODEL   202 as of 1.6.97,     208, 210.081 /281,     210 (except 210.081 /281) as of 1.3.97

A37 PSE control module (combined) (A37) CAN Controller area network N10/1 Driver-side signal-acquisition and actuation module (SAM) S6/1s2 Central locking interior switch 1 Pneumatic actuator on driver's door 2 Pneumatic actuator on passenger door 3 Pneumatic actuator on left rear door 4 Pneumatic actuator on right rear door Illustrated on sedan, models 210
		P80.25-0210-06

With thecentral locking interior switch (S6/1s2) it is possible to lock or unlock the vehicle with the exception of the tank flap.This does not activate or deactivee theanti-theft alarm (ATA). Actuation of the interior switch is recognized by thesignal acquisition and actuation module (SAM) (N10/1) .If the function of the switch is released the SAM transmits to the PSE control module (combined) (A37)the command to unlock or lock the vehicle via the CAN bus. The PSE unlocks or locks pneumatically. The interior switch is enabled via the CAN bus by the central locking or unlocking functions.

The following situations are possible: Driver or passenger door open: Only unlocking is allowed Locking from outside with key: Only locking is allowed. Unlocking from outside with key: When none of the doors is open, complete function. If the vehicle islockedwith the remote control key and the remote control key is then inserted into the ignition lock the vehicle is in the same state as if it has been locked with switch S6/1s2.